A commercial refrigeration interview has one job: find out whether this person can keep a rack, a machine room, and a set of cases running when a store is open and product is at risk. A long HVAC résumé does not tell you that. The questions below are the ones specialty hiring managers use for supermarket, cold-storage, and other rack work, written so an employer can use them as a script and a technician can use them to prepare.
This guide is about commercial and supermarket refrigeration — parallel racks, cases, leak response, and energy management systems — not residential service and not data center critical facilities. If you are still defining the seat, start with hiring supermarket refrigeration technicians. Facility Talent is a Phoenix-based specialty recruiter that places HVAC-R and commercial refrigeration talent nationwide.
Before the interview: decide what “good” is
Write down four things before anyone gets on a call: the systems the person will own (parallel racks, distributed systems, rack house packs, walk-ins, or a mix), the refrigerants and leak-detection setup in your stores, how many locations they will cover, and the night and weekend on-call rule. Every question below maps to one of those. If the panel cannot agree on them, the interview will turn into a conversation about whoever sounds most confident.
EPA Section 608 and refrigerant handling
Start here, because a strong technician who is casual about refrigerant is not a strong technician. EPA’s Section 608 technician certification requirements explain that Section 608 of the Clean Air Act (40 CFR Part 82, Subpart F) requires certification for technicians who maintain, service, repair, or dispose of equipment that could release refrigerants. EPA has four types: Type I (small appliances), Type II (high- or very-high-pressure appliances, except small appliances and motor-vehicle air conditioners), Type III (low-pressure appliances), and Universal (all types). Credentials do not expire. A supermarket rack is typically a Type II or Universal seat. Our guide to EPA 608 certification for employers covers the types, the sales restriction, and leak-repair rules in more detail.
- “Which Section 608 type do you hold, and when did you last recover refrigerant?” Listen for: a specific type (Type II or Universal for rack work), a recent job, the recovery equipment they used, and how they weighed and recorded the charge — not “I’m certified” with no detail.
- “Walk me through adding or removing refrigerant on a rack.” Listen for: identifying the refrigerant, checking the nameplate and the current charge, using recovery or charging practices that do not vent, and verifying the system after the work.
- “What would you do if a coworker started to vent leftover refrigerant?” Listen for: they would stop the work. EPA prohibits intentionally venting ozone-depleting refrigerants and their substitutes during maintenance, service, repair, or disposal, with limited exceptions such as de minimis releases during a good-faith recovery.
Racks, cases, and controls
This is the work that separates a commercial refrigeration technician from a general HVAC technician. Ask about the last rack they lived with, not a list of every brand they have seen.
- “Describe the last parallel rack you were responsible for.” Listen for: number of compressors, refrigerant, how the rack was staged, what the header and oil system looked like, and which cases or rooms it served. Vague “I work on racks” answers are a warning.
- “How do you diagnose a case that is warm when the rack looks normal?” Listen for: looking at case controllers, TXVs or EEVs, evap fans, airflow, defrost, and superheat or suction, not only “I’d add gas.”
- “Which energy management or case-controller platforms have you actually logged into?” Listen for: named systems they used to pull alarms, change setpoints, or see defrost schedules — and what they are careful not to change without approval.
Leak response and product risk
Owners and operators have leak-repair duties that a good technician should already take seriously. Under Section 608, EPA’s leak repair requirements apply to appliances with a full charge of 50 pounds or more of an ozone-depleting refrigerant. The 12-month trigger rate for commercial refrigeration (retail food and cold storage) is 20%. Beginning January 1, 2026, the AIM Act Emissions Reduction and Reclamation leak-repair requirements also apply to many appliances with a charge of 15 pounds or more of a refrigerant that contains an HFC or certain substitutes, with a 20% trigger for commercial refrigeration (40 CFR 84.106). Residential and light-commercial air-conditioning and heat-pump appliances are excluded from that AIM Act leak-repair program. This is not legal advice; confirm which rule covers each site.
- “Walk me through a leak call where product was at risk.” Listen for: how they found the leak, how they recovered refrigerant, how they protected cases or a walk-in, who they notified, and what they documented for the leak-rate calculation.
- “How do you decide whether a system can stay running while you repair it?” Listen for: product temperature, remaining charge, isolation valves, and a clear threshold for shutting a circuit down and calling the store or the facilities lead.
- “What records do you leave after you add refrigerant?” Listen for: date, amount, reason, and enough information for the owner or operator to calculate a leak rate. “I just topped it off” is a bad answer.
Route work, nights, and on-call
Multi-unit operators do not only hire for skill. They hire for people who will take the night call and cover a real route. Be honest about the radius, the on-call rotation, and whether the person will work alone in a closed store.
- “How many stores or sites have you covered at once, and what did a typical week look like?” Listen for: a realistic route, planned maintenance versus emergency calls, and how they prioritized when two stores called at once.
- “What on-call schedule can you keep for the next year?” Listen for: a direct answer. If the posting says nights and weekends, say so in the interview and believe the person who tells you they cannot do it.
- “How do you hand off a half-finished call to the next technician or to the store?” Listen for: what is running, what is isolated, what product is at risk, and what the next person should not turn back on.
Questions to skip
Skip questions about age, religion, national origin, disability, pregnancy, or other protected characteristics. The EEOC’s guidance on prohibited employment policies and practices is the place to start. You may ask whether the candidate can perform the posted schedule, travel between sites, and lift or climb as the job requires, with or without a reasonable accommodation. You may not use family or health questions as a shortcut to that answer.
How to use this in a real search
Pick six to eight questions, not twenty. Pair a lead technician with a hiring manager so one person can listen for rack and refrigerant detail. Use the same questions with every finalist so you can compare answers. When you write the posting, a clear job description helps the person this technician will report to: see our multi-site facilities manager job description template. For how multi-unit operators run the search itself, see HVAC-R supermarket refrigeration recruiting.
Working with Facility Talent
Facility Talent runs HVAC-R and commercial refrigeration searches nationwide from a Phoenix home base. Placement fees are typically 20–30% of first-year total cash compensation (base plus target bonus plus any sign-on), paid on hire, with a 60–180 day replacement guarantee. A priority search is a two-week engagement with a $5,000 fee, credited in full toward the placement fee. You can also post a job on Facility Talent Jobs for $149, or $349 for a 3-pack; we review and post within 24 hours. Call (602) 834-4850 or email hire@facilitytalent.com, or start a search from our HVAC recruitment page.
Sources
EPA Section 608 and the technician certification requirements; the venting prohibition and Section 608 leak repair requirements; the January 2026 AIM Act leak repair fact sheet (40 CFR 84.106); and the EEOC prohibited practices page. This guide is not legal advice. Confirm certification, leak-repair, and interview rules for the states and equipment you operate.
Frequently asked questions
What should you ask in a commercial refrigeration technician interview?
Ask the candidate to walk through a real rack or case call: how they diagnosed it, which refrigerant and controls they worked with, how they recovered or added refrigerant under EPA Section 608, and how they protected product temperature. Good answers are specific about steps, leak checks, and who they called, not just brand names.
Is EPA Section 608 required for a supermarket or rack refrigeration technician?
Yes, for anyone who maintains, services, repairs, or disposes of equipment that could release refrigerant. EPA’s Section 608 rules (40 CFR Part 82, Subpart F) require certification. Type II covers high- or very-high-pressure appliances such as most supermarket racks; Universal covers all appliance types. Credentials do not expire.
What is the leak-rate trigger for commercial refrigeration?
Two programs can apply. Under Section 608, owners or operators of appliances with a full charge of 50 pounds or more of an ozone-depleting refrigerant must act when the 12-month leak rate exceeds 20% for commercial refrigeration. Under the AIM Act Emissions Reduction and Reclamation rule, beginning January 1, 2026, similar 20% commercial-refrigeration leak-repair rules apply to many appliances with a charge of 15 pounds or more of an HFC or certain substitutes (40 CFR 84.106). Confirm which rule covers the equipment on your sites.
How is a commercial refrigeration interview different from a general HVAC interview?
A commercial refrigeration technician should be able to talk about parallel racks, case controllers, energy management systems, leak detection, recovery, and keeping product temperatures safe under load. A residential or light-commercial HVAC interview often stops at split systems, rooftops, and comfort cooling.
What questions should you avoid?
Avoid questions about age, religion, national origin, disability, pregnancy, or other protected characteristics. Start with the EEOC’s guidance on prohibited employment policies and practices. Ask whether the candidate can work the posted on-call and night schedule, not about family or childcare arrangements.